Quick answer: Furnace repair in Westwood costs $175 to $1,500, with inspection and diagnostic at $179 to $250 and blower motor replacement $300 to $600. Forced-air furnaces are the minority system in the Pascack Valley, where hot-water boilers dominate.
H. Hofmeister & Co. Inc. is a licensed NJ heating contractor (NJ HVAC License #19HC002574, NJ Master Plumbing License #10625) at 115 Bergenline Avenue, Westwood, NJ 07675. Family-owned since 1966. Hours are 6AM-6PM seven days a week with 24/7 emergency service. Call (201) 666-1118. This page covers gas and oil furnace repair - ignition, blower motors, heat exchangers and flame sensors.
Forced-air furnaces are the minority system in Westwood and the surrounding Pascack Valley, where hot-water boilers dominate - so a furnace here is often a later conversion or a newer build, and parts availability matters more than it would in a forced-air town. On a furnace the usual failure points are the igniter, the flame sensor and the blower motor, all of which are individually serviceable long before the unit itself is finished. We serve Westwood, Emerson, Hillsdale, River Vale, Washington Township and the surrounding Bergen County towns.
Forced-air furnaces are less common in the Pascack Valley than people expect, because much of the housing predates forced air as a default. That matters when you are choosing who works on it: a contractor whose week is mostly boilers still needs to be fluent in furnaces, ignition systems and duct static pressure. Where furnaces do turn up locally they are often in newer construction, in additions, or in homes converted from oil at some point, and conversions bring their own quirks in venting and duct sizing.
A furnace that hums but will not start is usually a capacitor or a seized blower motor. A furnace that lights and then shuts down within a minute or two is short-cycling, and the common causes are a dirty flame sensor, a blocked flue or an overheating limit switch tripping on restricted airflow. A furnace that runs but barely warms the house is usually airflow: a filter nobody has changed, a collapsed flex duct, or a blower running at the wrong speed. Blower motor replacement runs $300 to $600.
A clogged filter restricts airflow, the heat exchanger runs hotter than designed, the high-limit switch cuts the burner, and the homeowner experiences it as a furnace that keeps shutting off. It is the most preventable no-heat call there is. Check it monthly during the season and change it when light will not pass through it. If a new filter fixes the symptom, the underlying issue is still worth a look, because the furnace has been running hot for a while.
Furnace repairs run $175 to $1,500 depending on the part, with inspection and diagnosis at $179 to $250. Replacement is $3,500 to $5,500 for a standard 80 percent AFUE unit and $6,500 to $13,000 for high-efficiency, with ductwork modifications $500 to $2,500 where the existing runs are not up to the new unit. A cracked heat exchanger ends the repair conversation on any furnace regardless of age, because it is a combustion-safety failure rather than a performance one.
Call (201) 666-1118 — H. Hofmeister & Co. Inc., 115 Bergenline Ave, Westwood, NJ 07675.